Modelville Hobby

 

Al Stevens

Memorial Race

 

The 15th Annual Al Stevens Memorial Race will be held here at Modelville Hobby on  December 31, 2005     

Al Stevens Plaque.jpg (61647 bytes)

 

Official results of the previous races

.

1st Annual Results 1991

2nd Annual Results 1992
3rd Annual Results 1993

4th Annual Results 1994

5th Annual Results 1995
6th Annual Results 1996
7th Annual Results 1997
8th Annual Results 1998
9th Annual Results 1999
10th Annual Results 2000
11th Annual Results 2001
12th Annual Results 2002
13th Annual Results 2003

                          

You bring your Champion Turbo Flexi or Astro chassis and a Approved WSC body with no added air controls, pick a motor with gears and go racing.

 

Entry Fee is $20.00

FIRST $41.00 GIFT CERTIFICATE
SECOND $35.00 GIFT CERTIFICATE
THIRD $30.00 GIFT CERTIFICATE
FOURTH $25.00 GIFT CERTIFICATE
FIFTH $21.00 GIFT CERTIFICATE
SIXTH $18.00 GIFT CERTIFICATE
SEVENTH $15.00 GIFT CERTIFICATE 
EIGHTH $14.00 GIFT CERTIFICATE 

Based on a minimum of TWENTY racers.

 

CALL FOR MORE DETAILS

508-881-7616

 

The following is a list of allowed bodies for 2005 Annual Race

JK Products

Type
7085 Porsche 908
7192 Audi R8 Open Cockpit GTP
7184 BMW V-12 Open Cockpit GTP
7185 Cadillac Lemans Open Cockpit GTP
Parma Type
941 Porsche K-8
942 Kudzu WSC
1083 MG EX257 GT1
Champion Type
264 Nissan Lola WSC

Other Bodies by approval only.

 

Rules
All bodies must be painted opaque with only windows and front wheel wells left clear.
You should not be able to view the chassis when looking from above.
The under side of the body may be reinforced with tape, lexan and/or mylar.
Drivers are not allowed to modify the body design in any way.
Tape may be added to the outside of bodies to hold body mounting clips in place.
"Ninja Stars" or other body mounting hole reinforcements are allowed.
Reinforcements may be attached or strengthened with staples or tape.
All cars must have a three dimensional driver with a true head.
All cars must have rolling front wheels. 
Axles must follow NECC Rules.
One piece 0.047” or large steel axle for front axles, and 1/8” steel axles in the rear. 
Guide tongue reinforcement is allowed.
Chassis may be reinforced in the rear as per NECC Rules for GTP
All Chassis parts MUST be steel.
Lead wire holder maybe added to chassis.
Lead maybe added to the chassis.
Lead maybe added to the chassis.
All motors have been broken in.
No running of the motors allowed.
No practice laps with the race motor allowed.
The race will be run ROUND Robin with five minutes on and one minute off.  
The race will be on the Figure Eight with double lane rotation.
All cars will run the same gears (9-29 or 30) TBD.